Paradise Falls with Spillway Pond

The Paradise Falls with Spillway Pond was designed for corner placement featuring dramatic sheets of water cascading to the pools below. Both the upper and lower pools are designed for the use of underwater illumination. Ideal for patio and landscape settings. The Paradise Falls with Spillway Pond recirculates - there is no need for a pre-existing pool or pond. Shown in Desert Sand.

NOTE: This fountain includes special ordering instructions. Please read the 'Special Ordering Instructions' section above before placing an order.

WATERFALL MAINTENANCE
Running water is the key to keeping water clean. That's why we recommend putting your waterfall on a timer, so that your waterfall will be running consistently on a daily basis.

1. Change your water in your waterfall completely once a month.
2. You can use 2 chemicals for keeping your waterfall clean: Fountec and Protec.
3. Add water to your waterfall when evaporation occurs.
4. If waterfall is placed outdoors, where leaves and debris may fall into waterfall, then wrap pump with shade cloth screening material found at hardware stores.
5. DO NOT ALLOW PUMP TO FREEZE. Remove pump and water during freezing weather. If water freezes,
   it needs to thaw naturally without any physical force. Breaking frozen water on your waterfall could damage surface, and void warranty.
6. If waterfall has not been in operation for a period of time, you might find that the tubing will not allow the pump to pass water. If this happens use a garden hose water pressure to flush out any obstructions.
7. When placing real rocks in and around waterfall be careful not to cause splatter or damming by rock
   position.
8. If your waterfall obtains algae, and you would like to remove it then follow these steps:
   a) Remove water.
   b) Use a soft nylon brush and brush algae areas.
   c) Rinse areas with your garden hose.
   d) After waterfall is clean, place back where you had it, then fill with fresh water.
9. Waterfalls Indoors: DO NOT PLACE WATERFALL directly on wood, tile, or carpet surfaces, without
   putting a barrier material directly underneath for protection.
10. Although the waterfall is designed for minimal splashing, some splashing may occur.

PUMP MAINTANCE
This is a magnet driven pump powered by a water tight motor. Every two months clean the side intake cover, the rotor assembly, and regulator discharge, delicately in warm water and vinegar.

• Designed for corner placement
• Made of lightweight, durable resin
• Finished on all sides
• Available in three different colors
• Little assembly is required
• Warranty: 3 years limited, 1 year on pump

• Recirculating electric pump

2074+2202 - Paradise Falls with Spillway Pond (Granite)
2075+2203 - Paradise Falls with Spillway Pond (Iron Rock)
2073+2201 - Paradise Falls with Spillway Pond (Desert Sand)