Colorado Cascade Waterfall Fountain

The Colorado Cascade Waterfall Fountain is a mid-sized waterfall featuring dramatic sheets of water cascading to the pools below emitting a pleasing melody that will mask unwanted sounds. It features three levels. Beginning in the upper pond, the water branches in three directions to converge in the lower pond. To the right, water spills down two tier steps. To the left, water streams down a rugged slope while between the two, water gently trickles down the center. Ideal for patio and landscape settings. This waterfall fountain recirculates - there is no need for a pre-existing pool or pond. Available in three different colors. Shown in Iron Rock.

Realistic rock formations are made by casting the high-density urethane foam and letting it harden. Any part of this piece will not weather or rust.

NOTE: This fountain includes special ordering instructions. Please read the 'Special Ordering Instructions' section above before placing an order.

1. Change your water in your waterfall completely once a month.
2. You can use 2 chemicals for keeping your waterfall clean: Fountec and Protec.
3. Add water to your waterfall when evaporation occurs.
4. If waterfall is placed outdoors, where leaves and debris may fall into waterfall, then wrap pump with shade
   cloth screening material found at hardware stores.
5. DO NOT ALLOW PUMP TO FREEZE. Remove pump and water during freezing weather. If water freezes,
   it needs to thaw naturally without any physical force. Breaking frozen water on your waterfall could damage
   surface, and void warranty.
6. If waterfall has not been in operation for a period of time, you might find that the tubing will not allow the
   pump to pass water. If this happens use a garden hose water pressure to flush out any obstructions.
7. When placing real rocks in and around waterfall be careful not to cause splatter or damming by rock
   position.
8. If your waterfall obtains algae, and you would like to remove it then follow these steps:
   a) Remove water.
   b) Use a soft nylon brush and brush algae areas.
   c) Rinse areas with your garden hose.
   d) After waterfall is clean, place back where you had it, then fill with fresh water.
9. Waterfalls Indoors: DO NOT PLACE WATERFALL directly on wood, tile, or carpet surfaces, without
   putting a barrier material directly underneath for protection.
10. Although the waterfall is designed for minimal splashing, some splashing may occur.

• Finished on all sides
• Available in three different colors
• No assembly required (add water and plug-in)
• Warranty: 3 years limited, 1 year pump

• Recirculating electric pump